LLMTI=0, DUMMYB=0, DUMMYA=0, ZCI=0, CALONB=0, EOSIB=0, CIPA=0, EOSIA=0, CIPB=0, EOCALIA=0, EOCALIB=0, CALONA=0, HLMTI=0
HSADC Status Register
| CALONA | HSADCA Calibration execution status 0 (0): Calibration is not running 1 (1): ADCA is running calibration conversions |
| CALONB | HSADCB Calibration execution status 0 (0): Calibration is not running 1 (1): ADCB is running calibration conversions |
| DUMMYA | Dummy conversion running on HSADCA 0 (0): Dummy conversion is not running 1 (1): Dummy conversion is running on ADCA |
| DUMMYB | Dummy conversion running on HSADCB 0 (0): Dummy conversion is not running 1 (1): Dummy conversion is running on ADCB |
| EOCALIA | End of Calibration on ADCA Interrupt 0 (0): Calibration is not finished. 1 (1): Calibration is finished on ADCA. The IRQ occurs if CALIB[EOCALIEA] is asserted. |
| EOCALIB | End of Calibration on ADCB Interrupt 0 (0): Calibration is not finished. 1 (1): Calibration is finished on ADCB. The IRQ occurs if CALIB[EOCALIEB] is asserted. |
| HLMTI | High Limit Interrupt 0 (0): No high limit interrupt request 1 (1): High limit exceeded, IRQ pending if CTRL1[HLMTIE] is set |
| LLMTI | Low Limit Interrupt 0 (0): No low limit interrupt request 1 (1): Low limit exceeded, IRQ pending if CTRL1[LLMTIE] is set |
| ZCI | Zero Crossing Interrupt 0 (0): No zero crossing interrupt request 1 (1): Zero crossing encountered, IRQ pending if CTRL1[ZCIE] is set |
| EOSIA | End of Scan Interrupt 0 (0): A scan cycle has not been completed, no end of scan IRQ pending 1 (1): A scan cycle has been completed, end of scan IRQ pending |
| EOSIB | End of Scan Interrupt 0 (0): A scan cycle has not been completed, no end of scan IRQ pending 1 (1): A scan cycle has been completed, end of scan IRQ pending |
| CIPB | Conversion in Progress 0 (0): Idle state 1 (1): A scan cycle is in progress. The HSADC will ignore all sync pulses or start commands |
| CIPA | Conversion in Progress 0 (0): Idle state 1 (1): A scan cycle is in progress. The HSADC will ignore all sync pulses or start commands |